We will not reset failover_auth_time after setting it, this is used
to check auth_timeout and auth_retry_time, but we should at least
reset it after a successful failover.
Let's assume the following scenario:
1. Two replicas initiate an election.
2. Replica 1 is elected as the primary node, and replica 2 does not have
enough votes.
3. Replica 1 is down, ie the new primary node down again in a short
time.
4. Replica 2 know that the new primary node is down and wants to
initiate
a failover, but because the failover_auth_time of the previous round
has not been reset, it needs to wait for it to time out and then wait
for the next retry time, which will take cluster-node-timeout * 4 times,
this adds a lot of delay.
There is another problem. Like we will set additional random time for
failover_auth_time, such as random 500ms and replicas ranking 1s. If
replica 2 receives PONG from the new primary node before sending the
FAILOVER_AUTH_REQUEST, that is, before the failover_auth_time, it will
change itself to a replica. If the new primary node goes down again at
this time, replica 2 will use the previous failover_auth_time to
initiate
an election instead of going through the logic of random 500ms and
replicas ranking 1s again, which may lead to unexpected consequences
(for example, a low-ranking replica initiates an election and becomes
the new primary node).
That is, we need to reset failover_auth_time at the appropriate time.
When the replica switches to a new primary, we reset it, because the
existing failover_auth_time is already out of date in this case.
---------
Signed-off-by: Binbin <binloveplay1314@qq.com>
